Created with Sketch. Created with Sketch.
Toggle menu
FREE SHIPPING for orders over $100

Shop by Category

Turnout Motors

  • Hornby R8014 Mark 2 Point Motor

    Hornby R8014 Mark 2 Point Motor Powerful solenoid point motor for new model Hornby points that have the sliding bar mechanism. May be mounted above or below the baseboard (requires Point Motor Housing R8015 for mounting above). Comes supplied...

    $18.95
    Add to Cart
  • Hornby R8015 Point Motor Housing

    Hornby R8015 Point Motor Housing Provides a base to mount Point Motor R8014 above the baseboard, with a model trackside hut to conceal it. Comes with variable extension arm that allows you to position the motor at different distances from the...

    $12.95
    Add to Cart
  • Peco PL-10 Turnout Motor

    Peco PL-10 Turnout Motor The PL series of Turnout Motors is tried and tested, over the last 40 years Peco have sold literally millions of these motors. Simple, reliable and good value. An extended drive pin is fitted, use the PL-9 Mounting Plate...

    $15.95
    ** Out of stock **
  • Peco PL-10E Turnout Motor (with extended pin)

    Peco PL-10E Turnout Motor (with extended pin) The PL series of Turnout Motors is tried and tested, over the last 40 years Peco have sold literally millions of these motors. Simple, reliable and good value. An extended drive pin is fitted, use...

    $15.95
    Add to Cart
  • Peco PL-10W Turnout Motor Low Amp

    Peco PL-10W Turnout Motor Low Amp The PL series of Turnout Motors is tried and tested, over the last 40 years Peco have sold literally millions of these motors. Simple, reliable and good value. An extended drive pin is fitted, use the PL-9...

    $17.95
    Add to Cart
  • Peco PL-11 Side Mounted Turnout Motor

    Peco PL-11 Side Mounted Turnout Motor Clips directly into a Peco 00/H0 Setrack Turnout, either Left or Right Hand. No holes to drill, and this unit is pre wired. Can also be used with 00/H0 Streamline Turnouts. Other Products recommended with...

    $20.95
    Add to Cart
  • Peco PL-12X Turnout Motor Adaptor Base

    Peco PL-12X Turnout Motor Adaptor Base 2 Adaptor Bases are included, with optional extension arms, to enable PL-10 Turnout Motors to be mounted on the surface of the baseboard. This unit relies on the over centre spring in the turnout to keep...

    $4.95
    Add to Cart
  • Peco PL-13 Accessory Switch for Turnout Motors

    Peco PL-13 Accessory Switch for Turnout Motors Attaches directly to the PL-10 family of Turnout Motors with contact adhesive. This single pole switch can control frog polarity, ground signals etc. Peco PL-31 Push On Terminal Connectors can be...

    $7.95
    Add to Cart
  • Peco PL-15 Twin Microswitch

    Peco PL-15 Twin Microswitch This fits directly to the PL-10 family of Turnout Motors. The 2 single pole changeover switches can be used to control polarity, route selection diagrams, or 2 aspect colour light signalling etc. Rated 16v 2amps...

    $18.95
    Add to Cart
  • Peco PL-31 Push On Terminal Connectors

    Peco PL-31 Push On Terminal Connectors Contains 10 connectors and 5 shrouds. These connectors make modification and fault finding so much easier than soldered wiring. Use them to connect the PL-38 Wire to PL-26 Passing Contact Switches, PL-22...

    $6.95
    Add to Cart
  • Peco PL-34 Wiring Loom for Turnout Motors

    Peco PL-34 Wiring Loom for Turnout Motors Makes wiring the PL-10 series of Motors quick and easy. Just a simple push fit onto the motor terminals; the other ends are tinned and ready for the PL-39 Terminal Block, PL-50 Switch Module Unit, or...

    $11.95
    Add to Cart
  • Peco PL-9 Turnout Motor Mounting Plates (pack of 5)

    Peco PL-9 Turnout Motor Mounting Plates (pack of 5) Base unit for use with the PL-10E and PL-10WE Turnout Motors. Fixing screws and full instructions included. Other Products recommended with this item: Peco PL-10E Turnout Motor (with extended...

    $6.95
    Add to Cart